UTV Flare™ Windshield for Can-Am Maverick X3

The innovative UTV Flare™ Windshield, design features “hips” at the outer edge of the shield that re-route air, and the “flip” at the top is designed to kick the air up and back as clean, less turbulent air for driver and passenger. This means you’ll have all the wind and debris protection you need without sacrificing your ability to see! Unlike flat shields that don’t work if they are too low, or lost visibility if it’s too high, you’ll still be able to look over the Flare™, even after it’s caked in mud.

This sleek windshield is made from hard-coated polycarbonate and is available in three shades, clear, tint, and dark smoke. The kit comes with patented AXIA Alloys detach clamp hardware, roll cage J-clamps, and thumbscrew turn knobs, machined from billet-aluminum, then black anodized. Installation is a snap, and all necessary hardware is included. Check your fitment in the fitment section below.

+ Made from Dual Side Hard coated polycarbonate
+ Includes ALL mounting hardware - detachable
+ High quality rubber edge trim
+ Windscreen sits at same angle as front cage down tubes
+ Made to mount to OEM roll cage, but fits many aftermarket cages (with similar to stock dimensions)

Height from hood at flip (in front of driver/passenger): 13"
Height from hood at center: 10.6"
Width: 49.25"
Thickness: 0.160
Read More
$399.95

Fitment

  • 2017+ Can Am Maverick X3 and all Submodels

Part #

Part Name Part #
UTV Flare™ for Can-Am Maverick X3 - Clear 2317-0403
UTV Flare™ for Can-Am Maverick X3 - Tint 2317-0404
UTV Flare™ for Can-Am Maverick X3 - Dark Smoke 2317-0405

Install / Info

Installation Instructions